Mitsubishi L3E problems

[richp999]

Yep .. as suspected, another guvernor problem... good to see it resolved

Theres a solenoid switch controls the slew to the offset ram, but the default position is to cab slew. SO if the cab aint slewing ?

Thanks Muz.. I sorted this out yesterday.. After trying to follow the wire for an hour I ended up at a relay under the seat.

One of the spade connectors had dropped off, it was too old & not 'holding on' properly. Changed it for a new one , and the cab slew button now works fine. Must go through this relay then to the solenoid...